Velorex replica??
Hierarchický výpis
Textová verze
Seznam odpovědí (8)
-
Velorex replica??
06.08.2013 v 03:31
Jovan napsal:
Halo,(my only word of Czech I know)…..
I would like to build a replica of a Velorex 350, three wheeler.
I have many wonderful photos of the frame work, but really need some
dimensions of the tubing lengths and diameters.
Velorexs are rather few and far between in the U.S. I would of course
have to make some changes in the frame work in the rear suspension and motor
areas to work with whatever motorcycle engine/transmission drive I use.
Thanks John
Přidat odpověď
-
Re:Velorex replica??
06.08.2013 v 05:37
Beton napsal:
dobrý den
co já vím tak nákres jak je co ohnuté není
Přidat odpověď
-
Re:Velorex replica??
06.08.2013 v 15:10
Jovan napsal:
Thanks for the reply Beton. One of the dimensions I wondered about was
the diameter of the large round tubes along the sides of the frame?
Thanks John
Přidat odpověď
-
-
Re:Velorex replica??
06.08.2013 v 23:40, příloh: 1
Jovan napsal:
If I read the thread right, the main frame tubes are 32 mm?
Přidat odpověď
-
Re:Velorex replica??
07.08.2013 v 00:05, příloh: 1
Beton napsal:
označené trubky nejsou průměr 32
Přidat odpověď
-
Re:Velorex replica??
07.08.2013 v 02:19
Jovan napsal:
Oznacene does not translate for some reason. But from the picture you sent
back, I take it that all the tubing is 32mm, except the ones noted on the
drawing?
Přidat odpověď
-
Re:Velorex replica??
12.08.2013 v 16:50, příloh: 1
Jovan napsal:
Is there a difference in size between these front suspension pieces on the
Velorex 350, 250 and 175 cars?
Přidat odpověď
-
Re:Velorex replica??
24.08.2013 v 04:29, příloh: 1
Jovan napsal:
Looking for dimensions of the lower frame work of the Velorex 350. See
drawing. Also size of front „eyes“ for king pins, inside and outside
dimensions and length. Thanks.
Přidat odpověď
Předchozí dotaz: Velorex 435 Front Fenders
Následující dotaz: ŘADÍCÍ PÁKA
Zpět do kategorie Ostatní